01-12-2018, 06:33 PM | #1 |
RCC Addict Join Date: Mar 2007 Location: St. Louis (High Ridge)
Posts: 1,279
| Hairba11’s Datsun
I started thinking about updating the 8 year old build thread in the 1.9 section, but since all I’m reusing in half the chassis and the rear axle, and all the old photos are in the photobucket graveyard, I’m starting over. The original Datsun build was a cc01 chassis with leaf springs in the rear and an exo cage with a big bear body. Here goes round two. I hacked the back of the chassis off and added frame rails from 1/2x1/8 steel Then I made the kick up in the rear for the axle. A 3D printed Datsun cab fits nicely. A honcho bed finishes it nicerly. I made a floor pan from 22ga galvanized. It holds up the back of the cab and reinforces the rockers I hacked of more of what was left of the front end And made a simple skid plate Approach angle should be pretty good even with the IFS tombstone Then I attached the trayback to the back wall of the cab. I did math based on widths, and at 8.75” the blazer is about 9.4:1 so I printed the Datsun at 7.2” wide so it looks right. Putting them side by side the lifted Datsun is almost the same height as the stock blazer. Feels about right to me. Sent from my iPhone using Tapatalk |
Sponsored Links | |
01-12-2018, 06:50 PM | #2 |
Quarry Creeper Join Date: Nov 2015 Location: Walkerton
Posts: 445
| Re: Hairba11’s Datsun
Great looking build. Nice 3d body. I like those little old Datsun trucks.
|
Thread Tools | |
Display Modes | |
| |