wroncho about how much money would it cost to make a scx10 dingo have wraith axles and wraith links and everything u need to make it a wronchooo????? |
Re: wroncho Not to be an ass, but you have the internet. Go to RPP and price it out. The forum is very helpful, but we can't do everything for you. If you have a similar build in mind, re-create it and note the parts used. Find them and add it up. "thumbsup" |
Re: wroncho Assuming you already have a dingo... a set of wraith axles are 150 bucks. Then you will need slightly longer links. You will also need to chassis mount your steering with a panhard bar and 3 link. Same with the rear or you will need a center diff wraith axle. I didn't want to 3 link my rig so I made my own axle. Really you are looking at more time and self creativity on top of the price of wraith axles. Good luck! |
Re: wroncho Cost me right about $200.00. Axles with Poison Spider diff covers and new 4 link lay out. In hind sight should have spent the extra $40.00 on better steering linkage. Love it though. |
Re: wroncho Sorry for my earlier post. I may have come off a little too "tough lovish". My intentions were to keep you focused on learning HOW to build what you want to build, instead of relying on members to tell you exactly what to do. Members can make suggestions, and help guide you, but in the end, it's a lot of research and trial and error that will get you where you want to go. Best of luck on your build."thumbsup" |
Re: wroncho Check out this build: http://www.rccrawler.com/forum/axial...cho-build.html |
All times are GMT -6. The time now is 05:53 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com