Anyone tried these links?

[broncobill]

Has anyone tried these links yet?

http://www.rcrockcrawling.com/product_info.php?cPath=69_82&products_id=646

I just ordered them yesterday. I hope I can get them by the week-end, because we are planning on doing a little crawling Sunday.

[ruinx]

only down fall is that they were designed to be used on a stock wk chassis to give it 12.5" if you use them on a different cahssis that dose not have the same mounting holes you could end up too long or too short i had that problem with the strc extender kit. They look nice though"thumbsup"

[Offroader5]

Haven't tried them...but FYI, that kit is actually the RC4WD kit shown here.

http://rc4wdstore.com/product_info.php?cPath=1_71&products_id=699

Same stuff...but you can buy it directly from the manufacturer if you want "thumbsup"

[broncobill]

only down fall is that they were designed to be used on a stock wk chassis to give it 12.5" if you use them on a different cahssis that dose not have the same mounting holes you could end up too long or too short i had that problem with the strc extender kit. They look nice though"thumbsup"

I am using the WK chassis. I had made my own links out of threaded rod. 4-40 to extend the single mount upper link. But I kept on breaking it. Then I was going to make a 4 link out of 8-32 like my bottom links, then I seen the kit. So I figured I'd give it a try. Should be here today, or tomorrow according to USPS's web site.

[ruinx]

if you plan on comp ing and keeping the stock wk chassis then you will be fine"thumbsup"

[Locked Up]

The problem I see with the kit is that is extends the front & rear the same amount. I'd much rather have the back longer so the COG is pushed forward.

[AKRCC]

Did you notice that the stock WB on the WK is 9.4" and the rc4wd ext wb kit "says" it adds 88mm/3.46 to your wheelbase ?... If I do my math correctly... thats 12.86"... might be a misprint ;-) or i could be hook on phonix and not know how to read... or spell at that"thumbsup"

http://rc4wdstore.com/product_info.php?cPath=1_71&products_id=699

http://www.hpiracing.com/kitinfo/10830/

nope i read it right...

[broncobill]

I measured the axles before I put the tires on. 14" WB. There isn't any comps around here, so it's ok for now.

[LittleDave]

i used that kit and i hated it, mine flexes like ill crap. i dont know if its mounted all wrong or what, but mine really sucks. my front axle BARELY hits 45 degrees. i plan on re-building it with a different chassis and custom links.

just my .02