Kraqa
10-22-2008, 04:46 PM
Hey i'm new to Rc crawling but i'm startingn to buidl one from scratch.
I need to get my aluminum parts over to the laser cutters this week but i dont' have the parts (Axles, t-case etc....)
i dont' wana use a chassis templete from someone else.
Are any of you guys willign to share some files for axles, t-case, maybe even dig set-ups for me to use for sizing?
if a vendor has these files and is nto willign to give them up for free i have about 6 HPI motor clocking plates (Laser cut 1/8" 5052 AL) i would be willign to trade for accurate models of parts.
let me know.
kris
kfraser@surrtec.com
I need to get my aluminum parts over to the laser cutters this week but i dont' have the parts (Axles, t-case etc....)
i dont' wana use a chassis templete from someone else.
Are any of you guys willign to share some files for axles, t-case, maybe even dig set-ups for me to use for sizing?
if a vendor has these files and is nto willign to give them up for free i have about 6 HPI motor clocking plates (Laser cut 1/8" 5052 AL) i would be willign to trade for accurate models of parts.
let me know.
kris
kfraser@surrtec.com