stripped servo arm screw fix?

[rckjeep]

So It looks like I've stripped the servo arm screw on my H645MG servo. Can anyone give me any ideas? Oh and an aluminum servo arm too.

[JasonInAugusta]

might be able to tap the output shaft for a hair larger screw.

OFNA makes aluminum servo horns with plastic inserts to fit most anything.

[rckjeep]

yup those are the hors I've got. but the screw holding it in is a phillips and rounded out.

[Ace]

Can you get a new gear set? The screw threads into a gear...

[badger]

When I strip screws out I take my dremel and grind a flat head slot in it and then use a flat head screw driver to get it out. All you need it a little bit and make sure you put alot of pressure on the screw driver so it does not slip again.

I have extra screws if you need one.

[rckjeep]

Luckily I had the screw out a bit before it rounded out. so I hack a line in it and flat bladed it out. After heating up the screw head with a soldering iron. But I can't find a screw. So I'm reusing it.

John can you bring me one? I doubt I'll be able to find one in Morgan Hill tomorrow. So the LHS didn't have aluminum servo horn that didn't use the plastic adapters. But i bought another Ofna horn just for the plastic adapter. I guess I'll order one. Does anyone know if you can get just plastic parts?

[MaxxZilla]

I just used a little super glue.