PDA

View Full Version : Creeper build problems

Louis
02-02-2009, 06:35 PM
Well yesterday i bought my venom creeper and started working on it. all was great untill i realized i was shorted one bearing (no big deal, had a spare) but they did short me a tranny plug for the motor adjustment hole :/
other than that i am happy with the build.
1\4elliptic toy
02-02-2009, 06:37 PM
Duct tape! they will replace it...
Louis
02-02-2009, 10:29 PM
Also i don't know if it is me, but the metal outputs break really easily, ever easier than the plastic drive line. :roll:
I'm going to have to shell out 50$ for some mip ones i guess.
And also, do you know if the AX10 Drive lines will fit the creeper?

And i hate the residue duct tape leaves;-)
1\4elliptic toy
02-03-2009, 07:47 AM
Also i don't know if it is me, but the metal outputs break really easily, ever easier than the plastic drive line. :roll:



Explain this please? Outputs? Pictures? I have broken a rear driveline....but I deserved it :-P
ktmkurt
02-03-2009, 08:22 AM
Louis,
Venom-Group has very good customer support. PM
CrawlingAround. There was abatch of stub axles that were
over heat treated and Venom is aware of this. I had one snap
along with a few other peeps. Venom had mine delivered very
quickly. My kit also came w/o tranny plug and they sent it out too.
CRAWLINGAROUND
02-03-2009, 10:06 AM
Thats correct, if you contact us we can swap out the defective parts for you. "thumbsup"

Chris
Louis
02-03-2009, 01:02 PM
well i will send you guys a pm for sure. Other than these few issues i have had with the kit, its been amazing. I still give the kit a A+ even though there is a few problems.
http://i283.photobucket.com/albums/kk287/maker1010987/0203091338a.jpg
http://i283.photobucket.com/albums/kk287/maker1010987/0203091338.jpg
I have had three of them brake already, one of them i managed to fix by drilling it out and welding in a new ball joint part. And when they break its nothing special, ill just be crawling (even up my couch) And one will just break.
Louis
02-05-2009, 05:48 PM
UPDATE!!
Well after crawling around a little i managed to snap TWO pins in the front drive shaft to the wheels, the one inside the joint itself and and on the whel hub.. :/ I hate breaking parts, and no one has gotten me back about my first roblems