Mip drivelines

[Louis]

Hello Everyone, i was wondering if the AX10 MIP CVS'S will fit the creeper?
has anyone tried them yet? Or are there metal drivelines for the creeper?
http://i283.photobucket.com/albums/kk287/maker1010987/MIPpr1.jpg
Anything helps.
THANKS

[1\4elliptic toy]

No they will not fit, they are to long, I had a broken shaft just like yours, I went to my LHS and looked at all the d-lines there. The traxxas ones fit perfect but "all" the axials I looked at were to long.

[Louis]

well if it is a little too long, i have a laithe and any tool to shorten them up a little, but the question i want to know is, Are the output yoke sizes the same."thumbsup"

[1\4elliptic toy]

well if it is a little too long, i have a laithe and any tool to shorten them up a little, but the question i want to know is, Are the output yoke sizes the same."thumbsup"

Yep, it is, I took this shot just to show you the extra length of the creeper tranny. You will need to mill of at least 1/2 inch probably more like 3/4 from memory.

[Louis]

well did you notice how in my picture above of the ax10 MIP D-lines that the top one is alot shorter? i think thats for the DIG. is there a way you could mesure how long you AX10 drive lines are for me?
I know that i can buy the MIP DIG Metal drivelines

[Louis]

http://www.thundertechracing.com/onlinestore/products.php?cat=43
Check out those girls on the top of the page. they are 3.5 inches long, the exact length needed for the Venom Creeper!!"thumbsup" The only down fall is the dam price of them!! 60 BUX!!
ouch:roll: