My Pajero

[trailduster79]

Here is mine.


Has a rooster crawler ESC, Axiom 45 turn motor, Hitec 645MG Servo.
Running stock rims and 1.9 mudslingers.

I have a small body lift.

Hope to add a LED kit and do some trimming to the front end for better approach angles and finish detaling the body with turn signals and what not.

[tom tom]

That's a small body lift? Haha, jk"thumbsup"

[sgil2001]

Nice! What pinion did you use with the Axiom 45T? Is everything else in the trans stock?

[trailduster79]

Nice! What pinion did you use with the Axiom 45T? Is everything else in the trans stock?

Yes everything else is stock. I believe I used the factory pinion because I didn't have any other metric pinions

[trailduster79]

That's a small body lift? Haha, jk"thumbsup"

It took that much to fit the tires without rubbing. I will probably trim the fenders and lower it back down some

[tom tom]

It took that much to fit the tires without rubbing. I will probably trim the fenders and lower it back down some

Yeah, I did the exact same thing. Cutting the fenders does make them look a little more realistic. Also, getting some 3" shocks and mounting them around all four corners will help too. The front A-arms take some grinding to swing far enough down. It increases ride hight, articulation, and makes the maximum shock compression longer, which also helps the rubbing issue. I am also tying to figure out how to modify the front end so I can put a uniform skid plate on it. If you figure that out, please let me know. Thanks