TA02 Chevy

[NP435]

Here is my TA02.
Parma stepside chevy body
55t lathe
futaba gear and esc
water proofed
cut stock tlt tires and wheels
lexan mud shields
http://i56.photobucket.com/albums/g169/bronco69/ta02front.jpg
http://i56.photobucket.com/albums/g169/bronco69/ta02rear.jpg
http://i56.photobucket.com/albums/g169/bronco69/ta02side.jpg
http://i56.photobucket.com/albums/g169/bronco69/ta02framerear.jpg
http://i56.photobucket.com/albums/g169/bronco69/ta02frame1.jpg
http://i56.photobucket.com/albums/g169/bronco69/ta02frameside.jpg
what do ya think

[trost]

flex shots?:roll:

[thaclodking]

That rig has seen alot of mud....

Looks cool, and good use of a set of stock TLT tires. That is what I am going to use on my TC3 trail runner.

[NP435]

No flex shots, its for mud.

Thanks, the tires worked way better in mud and dirt after cutting them.

[maxxdrive]

looks good i have a set of tlt tires on a tamiya hummer i did

[sybir]

I like it, I'm running the same setup with a Toyota Prerunner body. The TLT takeoffs are perfect on these cars, all I did was trim the bumper a bit. Have you had any issues with the motor fouling out in the mud, being down as low as they are?

[NP435]

No issues with the motor yet, I need to clean it though. I have been breaking the plastic dogbone ends, I put stock tlt bones in their place. They work OK if you center them with springs.

[skidooguymxz550]

a whole lot of good those lexan mud shields did you

[NP435]

Yea, they were more for keeping rocks and crap out of my steering, they work good for that.

[Mad Scientist]

Nice. Now go hose that thing off, and do it again!