Hot Racing Lock Outs - Which Bearings? I've just bought the HR rear axle lock out kit and i can't work out which bearings to put in. Do i just leave the one in the end of the axle, and put the smaller one from the hub in the alu lock out? I assume the larger bearing in the hub is not needed. Hope that makes sense. I have searched and can't find the answer, so thanks for any help. Neil |
you use one big one and one small one in the lockout take the one out of the axle tube. thats what i did |
The big one from the inside of the hub doesn't fit into the Hot Racing Lock out. I could only get 1 small one in there and i left the small one in the end of the plastic axle. Hope that is right ! |
With the HR lockouts, you'll only use one 11mm (smaller one) bearing in each side. It'll slide into the lockout body. |
Thanks You ! That's what i ended up doing, i just hoped it would be ok. |
All times are GMT -6. The time now is 02:17 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com