|
| LinkBack | Thread Tools | Display Modes |
05-22-2008, 11:16 AM | #1 |
I joined the Band! Join Date: Mar 2008 Location: All over the place
Posts: 152
| Hot Racing Lock Outs - Which Bearings?
I've just bought the HR rear axle lock out kit and i can't work out which bearings to put in. Do i just leave the one in the end of the axle, and put the smaller one from the hub in the alu lock out? I assume the larger bearing in the hub is not needed. Hope that makes sense. I have searched and can't find the answer, so thanks for any help. Neil |
Sponsored Links | |
05-22-2008, 01:21 PM | #2 |
Rock Crawler Join Date: Dec 2007 Location: GILBERT
Posts: 751
|
you use one big one and one small one in the lockout take the one out of the axle tube. thats what i did
|
05-22-2008, 02:52 PM | #3 |
I joined the Band! Join Date: Mar 2008 Location: All over the place
Posts: 152
|
The big one from the inside of the hub doesn't fit into the Hot Racing Lock out. I could only get 1 small one in there and i left the small one in the end of the plastic axle. Hope that is right ! |
05-22-2008, 07:00 PM | #4 |
Quarry Creeper Join Date: May 2006 Location: Volcano, Hawaii
Posts: 429
|
With the HR lockouts, you'll only use one 11mm (smaller one) bearing in each side. It'll slide into the lockout body.
|
05-23-2008, 03:50 AM | #5 |
I joined the Band! Join Date: Mar 2008 Location: All over the place
Posts: 152
|
Thanks You ! That's what i ended up doing, i just hoped it would be ok. |
| |