semi-droop questions on my ax-10, i have half of a mini-t spring inside every shock, with 80wt oil. the ride height is at 2in. the droop is about 3.5in. how can i get a little more ride hieght with out sacrificing the droop? |
add some fuel line to the outside of the shock shaft to limit how far it droops. |
Quote:
What the op could do though, is add external springs and adjust until height is right. |
I'm assuming the mini-t spring is on top of the piston to give you the 2" of ride height. Just go a little longer than you have already. More spring inside shouldn't mess with the ride height all that much unless you are looking for alot more height. The other thing you could try is a longer ball end to lengthen the whole shock. |
Quote:
|
I am running Integy MSR-10 shocks, up front I have soft springs and 30 wt. and in the back I have no springs and 30 wt. I want to switch to 50 wt, with same spring setup. I like not having the springs in the back, seems like the rear end just goes with the flow. I have experienced less roll overs and quite a bit of articulation from it. The MSR-10's are a pain to get right with fluid. |
Quote:
|
All times are GMT -6. The time now is 01:14 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com