Finally - going LiPo with my AX10 Finally making the switch after running NiMh's for awhile. I ordered up two of these: http://www.allerc.com/product_info.p...oducts_id=4534 With my setup, any guessimates on what my run times might be? FXR Integy 55t CC BEC at 6.0v Hitec HS-645 Steering Servo JR Z590 Dig Servo (VP Hurtz) Stock Chassis Mayhem CDP's with Rovers I thought about going 3S on the LiPos, but they were close to 2x as much and being my first venture into LiPo, I wasn't ready to spend that much yet. Any other suggestions or advice would be greatly appreciated. Also, do I need the Hotwire for the FXR to program the LVC for the LiPo or is it easy enough to do w/o? Thanks! SS |
glad you could make the switch, you will be very happy with them. for the castle sidewinder, you go in and program the lipo cutoff to 6.0V for a 2S, 3.0V per cell. so a 3S would be 9.0V. im not sure how to program it into the FXR but that's how you do it on the Castle stuff. i get about 30 mins of run time with my 3s 1320 mah lipos, running a 35T motor. so i would say you will get about 20 mins or so? |
id expect atleast 30-40 minutes with a 55t |
yes, forgot it was a 55t :? |
ok - good thing i got two of them.... and they charge fast too. SS |
I read some people are setting the LVC to 3.2 to 3.5 per cell... should it be 3, or is it better to play it safe and go higher? SS |
i talked to a friend and he said 6.2V is what some people run. i like to be on the save side because lipos are costly, and run 3.0V per cell |
Quote:
SS |
Quote:
|
Got these in yesterday. Must say, that is pretty damn quick shipping. They are so small and light, I can't wait to ditch the NiMh packs. Now I just have to figure out the best place to mount it. Got the deans soldered on last night, and since I don't have the hotwire yet, I also just set the FXR to 2S cuttoff at 6.0v. The little driving I did in the garage last night after a charge, I was impressed with the wheelspeed I gained. SS |
go to 3s and don't look back"thumbsup" Only a few bucks more not 2x: http://www.allerc.com/product_info.p...oducts_id=4508 |
All times are GMT -6. The time now is 03:44 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com