vp hubs for sportsman???

[s2000ax10]

New here to rccrawler

Was looking at getting a set of the DH procomp 2's for my sportsman and have no idea what hub size to get do I get the hex spacers or do I need to get a combination of both of them. I was thanking of getting the 585 hex spacers for the back and the 710 hubs for the fount or would it be to wide for the them?


I have boss claws and they do rub the shocks when turning any help would be appreciated thanks.

[TSK]

This question is better suited for the "Tire & Wheel" section, but VP's website also list's what hub size will give what track width for your application. Most guys typically shoot of an outside to outside (of rim) width of 10.75-11"

The setup you suggested would give you a significantly narrower rear rack width, which will most likely lead to some stability issues. In most cases, one size smaller will suffice if you want a narrower rear track

[Duuuuuuuude]

somewhere on VP's site there is a breakdown of the hub sizes. There is also a thread in the wheel and tire section that helps explain it also. Its been a few weeks but if you poke around you'll find it.

Welcome to RCC.

[s2000ax10]

Will go look

Thanks

[s2000ax10]

found the chart on VP's website

[Hittman]

Originally Posted by s2000ax10

I was thinking of getting the 585 hex spacers for the back and the 710 hubs for the front

Exactly what i run.. Works perfect. I am running sedonas and have no rubbing issues at all.

[Hittman]

Actually i run the dhII's up front with the dh710 hubs with sedonas with no rubbing problems and i run the slw v2 in the rear with dh585 hubs with rovers.