| |
08-12-2012, 02:07 PM
| #1 |
| Newbie  Join Date: Jul 2012 Location: glenville
Posts: 12
|  How to 4 link?
I have searched quite a bit and am aparently not very good at using the search. I want to four link my ax10, I have front and rear mount plates but am not sure about the links. Are you guys just simply removing the y link, and threading ends into the tubes?
|
|  |
| Sponsored Links | |
| | |
|
08-12-2012, 03:11 PM
| #2 |
| I wanna be Dave Join Date: Jul 2009 Location: Rancho Relaxo. California. USA. Earth.
Posts: 3,292
| Re: How to 4 link? How To: Make your own links Alot of useful info in there with a few ways to make links. Use the lowers to set your wheelbase and uppers to set your pinion angle among other things. Do alot more searching with simple terms and reading. Good luck and welcome to the addiction  |
|
| |
|
08-13-2012, 05:33 AM
| #3 |
| Newbie Join Date: Jul 2012 Location: glenville
Posts: 12
| Re: How to 4 link?
Thank you for the info, I was looking everywhere.
|
|
| |
 |
How to 4 link? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wraith TEAMSTRC steering link/drag link???? | SwampDawg | 2.2 Scale Rigs | 1 | 07-02-2012 04:03 PM |
| Steering link and drag link - what's the best bang for the buck? | Matthewboerner | Axial Wraith | 29 | 10-25-2011 10:25 AM |
| Link setup on TCS 4 link plates and boulder chassis | sdcrawls | Axial AX-10 Scorpion | 8 | 11-17-2009 02:37 AM |
| |
Linear Mode
