my ax10 makeover
 

haven't posted anything on here in awhile,thought i would share what mods i have done. i basically did my own stage 2 mods, four link with longer links up top, high clearenced the bottom links, also moved them inboard on the skid and axles, using losi yellow springs on front shocks and pinks on the rear. put the rubber spacer under the piston and used 3/8 piece of fuel tubing on the out side of the shock to limit flex. had a stadium truck body on it but at last weekends comp the tires kept catching the body and rolling me over. i just mounted a bug body on it and is much better now. here are some pics.:roll:

Looking real good man!

Still running the 50/50 Droop set up?

I can't find a bug body in stock ANYWHERE!

very nice! like the bug body,where did ya find that?

biaryterror yeah still running 50% droop. couldn't find a hpi rs4 baha bug anywhere so i went with the hpi e-savage bug body i think i like this one better."thumbsup"

Great mods"thumbsup", I really like the lower links and bug body

thanks for all the compliments,now i have to get the aluminum hop up when they are back in stock. i noticed that i spun a hex halfway in one wheel. need to order some msd beadlocks when they are in stock also.:roll:

i upgraded my rims to aluminum beadlocks, i can't believe how much nicer these rims are. nice and heavy no need to add weight, go together easy and hold the bead like no tommorow. also polished my lower links a little bling bling, here are a couple pics.thanks for looking gary.:lol::roll:

Looking real nice!

thanks jake, the stock losi foams are alot better than what i had in it"thumbsup".

Nice job my Michigander brother that really looks awsome:lol:"thumbsup"

I was running those same aluminum beadlocks on my AX10 with the stock knuckles and busted 'em up real fast. I switched back to the AXIAL plastic beadlocks with the Masher 2000s and it works like a champ...I swapped the alum eadlocks to my SW3 with alum upgraded knuckles and axle housing and they are holding up there for now.

Very nice rig by the way!

thanks, i'm a little nervous about the stock knuckles breaking as theses rims are heavy just waiting for rcp stuff to get back in stock, hope its soon..:cry:

Gary, I have my old Knuckles and C's if you run into any problems.

I ran my stock plastic with those Alum beadlocks for some time without issue.

thanks jake, i will run them till they break, just hope rcp gets there stuff soon just want my rig to be complete.8)

Shrek check out rc4wd they have c-hubs and knuckles in stock right know

Wait for the RCP stuff...extra steering and in black :)

Oh whats this...the truck you copied from? hehehe. Added the Countersunk screws in Blue Plated (for extra wear and strength) Steel screws.

so is the stuff from rc4wd its all black anodized"thumbsup"

huh? my rc4wd knuckles and c's are polished! They work great though, I wanted the silver look. I have RCP's knuckles and c's on my wk and they are great too!

rc4wd's straight axle adaptors are black anondized

I just got off there site and I just order them c-hubs and knuckles and they are black anodized

justgoingslow rc4wd is still out of stock on there straight axle adaptors, i want to buy everything at once, think i'll just wait for the rcp parts to come in i want the rear straight axles too.:roll:

jake looks good. gotta do whatever makes your rig the best it can be right:?: