RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Axial AX-10 Scorpion (http://www.rccrawler.com/forum/axial-ax-10-scorpion/)
-   -   squeeky locker?????????? (http://www.rccrawler.com/forum/axial-ax-10-scorpion/94304-squeeky-locker.html)

jwilli2213 12-02-2007 03:14 AM

squeeky locker??????????
 
when i turn my wheels hard left or right and go forwad there is a squeeky noise is this my locker starting to wear???

thatguy 12-02-2007 04:30 AM

tire squeal.

JUSTGOINGSLOW 12-02-2007 07:41 AM

Did you lube the locker really good when you assemble it "thumbsup"

jwilli2213 12-02-2007 10:03 AM

Quote:

Originally Posted by JUSTGOINGSLOW (Post 945506)
Did you lube the locker really good when you assemble it "thumbsup"

ya but its been like 3 monthes that iv been using it should i have to lube it again

JUSTGOINGSLOW 12-02-2007 10:54 AM

would not hurt to look and see whats going on in there "thumbsup"

toyofast 12-02-2007 11:28 AM

Quote:

Originally Posted by jwilli2213 (Post 945422)
when i turn my wheels hard left or right and go forwad there is a squeeky noise is this my locker starting to wear???


How about looking at where your wheels might be rubbing or the hexes rubbing on plastic. It's most likely at or near the hubs/knuckles. Are the bearings that the axle stubs ride on dirty or lacking lube? That area sees more wear and abuse than the inside of the axle housing.

mikenredding 12-02-2007 10:31 PM

I just finished mine. when I run it I hear like loud gear noises is that normal?

WKKILLER 12-02-2007 10:38 PM

Mike,

I don't think that is normal. Mine did not make any loud noise.

Gizmo 12-02-2007 11:05 PM

Quote:

Originally Posted by jwilli2213 (Post 945422)
when i turn my wheels hard left or right and go forwad there is a squeeky noise is this my locker starting to wear???

mine squeaks under the same conditions. Mine was just the rear driveshaft squeaking at the joint on the axle... You might want to check that out

jwilli2213 12-02-2007 11:55 PM

Quote:

Originally Posted by toyofast (Post 945744)
How about looking at where your wheels might be rubbing or the hexes rubbing on plastic. It's most likely at or near the hubs/knuckles. Are the bearings that the axle stubs ride on dirty or lacking lube? That area sees more wear and abuse than the inside of the axle housing.

i will look


All times are GMT -6. The time now is 03:11 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com