New links for my axial Made some new links for the rear. What do you think? http://i79.photobucket.com/albums/j1...r/100_2687.jpg http://i79.photobucket.com/albums/j1...r/100_2688.jpg http://i79.photobucket.com/albums/j1...r/100_2691.jpg http://i79.photobucket.com/albums/j1...r/100_2692.jpg http://i79.photobucket.com/albums/j1...r/100_2690.jpg |
Nice work...mine are very simular. |
Very nice job Rockcrawler what size tube did you use I was asking because I made my own 70mm upper links out 3/16 solid rod and they turned out pretty good "thumbsup" |
Thanks guys. I believe its 1/4 . But the best thing is that its stainless. Slides very nice on the rock. "thumbsup" When I get everything setup, I am going to make better looking links, just trying to get the length and angels right."thumbsup" |
how long are thoes links in inches? |
Quote:
125mm or 4.92 inches Center to center.;-) |
Nice ! I made some out of 1/4 inch 316 L stainless and love them. I cut mine 4.000 long and bent a 3/4 rad 1.5 inches from 1 end. Makes it only slightly longer than stock. I like the heavy weight links on the bottom,I was running some I made out of black delrin.The flex was good and bad,but the COG differance the S.S. ones make is worth it's weight! |
Stainless is the best I have found to use because of the fact that there strong, and slide very well on the rocks. ;-) Dave, do you run comps? I dont think you can with those links because of the WB. |
No comps yet... The wheel base came out within a 1/4 in of stock. The nice thing is I was able to get a killer pinion angle. I made a home brew 4 link mount out of 1/4 inch 4140 bar stock for the rear and run much longer than stock links on top. Again the heavy weight in the right spot...centered on the axle. |
Quote:
Did you go ahead and 4 link it? |
where do you find stainless to make those? |
Quote:
Free from work. :lol: I guess a plumbing shop or something. |
Quote:
|
Quote:
|
BLING! "thumbsup" |
Those look really nice! Did you have to tap (thread) the stainless rods or did they come pre threaded? |
Quote:
|
Hay Rockcrawler what is the degree of angle right now and how far up do you have the bend |
Not real sure on the angle. I just had 2 spare pieces sitting here so I bent one until it looked right, then just matched the other. I am still working on them so things are going to change. I have already cut 1/4" off of the bent side. Still needs a little more to get them level. |
I think i'm going to make the attempt to make my own bent links I have to just get some kind of a angle gauge just to get close but pretty much by eye |
All times are GMT -6. The time now is 05:56 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com