01-05-2008, 12:43 PM | #1 |
Newbie Join Date: Sep 2007 Location: BG
Posts: 26
| Axial SW3 R2D
Hi Guys - need some help please ( I think ) I have my AX10 part built here and a SW3 chassis in the post and a R2D in another package in the post. I just looked at the pictures on the net again of the tranny and notice the output shafts have holes drilled through them ???? So how are my Axial driveshafts going to fit on there then ? - is it as simple as just using long grub screws ? surely not TIA |
Sponsored Links | |
01-05-2008, 01:30 PM | #2 |
Rock Crawler Join Date: Mar 2007 Location: Colorado
Posts: 635
|
I beleive so...
|
01-05-2008, 02:41 PM | #3 |
RCC Addict Join Date: Sep 2007 Location: WHEAT RIDGE, CO
Posts: 1,102
|
racechat: I'ld recommend ya drill the holes..I used the maxx-shafts and even running two set screws, had bad luck trying to keep on or even centered for that matter. |
01-05-2008, 03:24 PM | #4 | |
20K Club Join Date: Jul 2004 Location: Sending illegals home one Hayabusa at a time.
Posts: 22,981
| Quote:
I use an extra long set screw, similar to a max shaft pin. You can get them at Ace hardware in the set screw bins, they are about 30 cents each. | |
01-06-2008, 01:20 AM | #5 |
Newbie Join Date: Sep 2007 Location: BG
Posts: 26
|
Thanks for the replies - a long set screw it is then I think. I'm assuming the hole is 3mm then ? (like I said my tranny isn't here yet) |
| |