question about the vanquish knuckles I ordered did I mess it up?

[Spence]

Hi guys, I had some issues with my STRC steering links they are terrible, sure its an upgrade over stock, so I bought the vanquish incision stainless steering link set that is much better designed. The STRC ones are horrible in that they use small diameter machine thread grub screws that thread into the ball ends and then get threaded into the links, and yea not good, the link ends pull out and the threaded area loosens up.. I just bought for my ax10 deadbolt "project orange" I bought these: Vanquish Axial Wraith Knuckles Orange VPS03202 | eBay

I am running the stock c hubs stock axle housings, but I really liked the orange and its really my first real vanquish product... I also bought the vanquish bronze bushings that go into these. I just don't know if these will fit the stock c hubs, it says: Fits all Axial AX10, Axial SCX10 and Axial Honcho kits with Vanquish 8 Degree Chubs

so do I need to buy the vanquish c hubs too? I am going to get the xtra speed axle housings at some point too. The vanquish ones are silly expensive...

Thanks
-Spence

[Sneetches]

Just to clarify but I'm assuming you have an AX-10 with AR60 (wider) axles that uses Wraith parts. In that case they should fit fine.

[Spence]

Originally Posted by Sneetches

Just to clarify but I'm assuming you have an AX-10 with AR60 (wider) axles that uses Wraith parts. In that case they should fit fine.

I mean they are labeled as fitting the wraith, I have the ax10 deadbolt which is the 2nd gen of ax10 which is discontinued which does use the ar 60 axles which every non scx10 axial rig uses... Thanks