Capra Dig & Futaba 4PM

[Mackied]

Ok I’m new to this and never set up any electronics before. I have a Capra RTR and bought a futaba 4pm.
Not too sure how to set up the dig.
Anyone able to help or point me in right direction?


Sent from my iPhone using Tapatalk

[Panther6834]

If you check the main Capra thread, you'll find lots of info...how to set for 2-position, how to set for 3-position, what servos to use besides the SX107, etc.


~ More peace, love, laughter, & kindness would make the world a MUCH better place

[Mackied]

Originally Posted by Panther6834

If you check the main Capra thread, you'll find lots of info...how to set for 2-position, how to set for 3-position, what servos to use besides the SX107, etc.


~ More peace, love, laughter, & kindness would make the world a MUCH better place

Thanks, got stock in just now waiting for Reef 99 for dig to come.


Sent from my iPhone using Tapatalk

[Panther6834]

Originally Posted by Mackied

Thanks, got stock in just now waiting for Reef 99 for dig to come.


Sent from my iPhone using Tapatalk

2-position is super-easy to set up. If you want 3-position, it takes a lot of time, effort, and (especially) patience...but, again, you'll find all the info in the main Baja Rey thread.


~ More peace, love, laughter, & kindness would make the world a MUCH better place

[jeepgeek2002]

Harley on Youtube has a video on how to set up the dig.
I have a 4pls compare to his 4PM but same names different screens. i put dig on DT2 i think it works perfectly as a 2 position.

[OnTheTrail]

While not the Futuba, I set up my Capra dig on my Flysky GTS5 on the three postion switch using the stock dig servo. Not too difficult. Little tweaking but I've got it set up for all wheel drive, front wheel drive only (did this to take stress off the drivetrain when trailing on heavy traction surfaces every once in awhile do to rear underdrive) and dig. Works well. Actually fun to drive around and see what all you can tackle in front wheel drive only. (Hint: not to much but fun nevertheless)

Just work through the manual or online tutorials. VERY important to disconnect the servo arm during the initial set up to keep you from burning up the servo if you overdrive it before you tweak the end points.

Best of luck.