RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Axial RR10 Bomber (http://www.rccrawler.com/forum/axial-rr10-bomber/)
-   -   Fix AR60? (http://www.rccrawler.com/forum/axial-rr10-bomber/605431-fix-ar60.html)

Snakeob 01-12-2019 07:59 AM

Fix AR60?
 
Striped spool on the front, i am sure i hurt it when i broke an axle shaft. New shafts finished it off. A few of the teeth on the ring gear are not looking so hot. Whats available for gears and locker? No sense in replacing with same quality right?

Jboucher 01-12-2019 08:03 AM

Re: Fix AR60?
 
Locked up RC FI spool and axial HD gears

Simple fix

Sent from my Pixel 2 XL using Tapatalk

Fives 01-12-2019 09:14 AM

Re: Fix AR60?
 
Seconded. Just put a Locked Up spool in my Bomber after realizing I’d split the axial locker in half, and really happy after some testing. Will be pounding on it today!

WHITE-TRASH 01-12-2019 11:28 AM

Re: Fix AR60?
 
Locked up, incision etc are all good. Axial or hot racing gears.

Snakeob 01-12-2019 12:07 PM

Re: Fix AR60?
 
Whats the general consensus about ratio change?
pitbuls/brushless, all stock gearing now.

Jboucher 01-12-2019 12:13 PM

Re: Fix AR60?
 
I went 11T for the pinion with my 550 21T to get more low speed control.
Stock spur, stock axles

I know some people like to underdrive the rear for crawling.

Sent from my Pixel 2 XL using Tapatalk

WHITE-TRASH 01-12-2019 01:15 PM

Re: Fix AR60?
 
Quote:

Originally Posted by Snakeob (Post 5900143)
Whats the general consensus about ratio change?
pitbuls/brushless, all stock gearing now.

Under drive gears are stronger than over drive and stock ratio. I run stock ratio front and under drive rear in most of my rigs, bomber incluxed.

Teng 01-12-2019 04:04 PM

Re: Fix AR60?
 
Quote:

Originally Posted by WHITE-TRASH (Post 5900156)
Under drive gears are stronger than over drive and stock ratio. I run stock ratio front and under drive rear in most of my rigs, bomber incluxed.


Wise enough’s combination. Bearing bearing AR60 from dlux and a good shimming also very important to consider.


All times are GMT -6. The time now is 10:39 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com