| |
03-03-2019, 08:49 AM
| #1 |
| Pebble Pounder Join Date: Oct 2006 Location: Montreal
Posts: 199
|  Notchy rear diff...
I'm building my bomber kit and the rear diff is really tight. The problem seems to be that the axle on the ring gear side is pushing the ring gear into the pinion too hard. When I remove the rear lockout on the ring gear side everything spins smooth. As far as I can tell all the bearings are seated properly. Any suggestions?
|
|  |
| Sponsored Links | |
| | |
|
03-03-2019, 09:14 AM
| #2 |
| I wanna be Dave Join Date: Jun 2016 Location: Deep in the Everglades
Posts: 5,818
| Re: Notchy rear diff...
Did you shim the pinion Hang up and Drive |
|
| |
|
03-03-2019, 09:56 AM
| #3 |
| Rock Stacker Join Date: Dec 2012 Location: HESPERIA, SoCAL
Posts: 74
| Re: Notchy rear diff...
With the axle assembled. Chuck the pinion in a drill. Run it forward and reverse to break-in the gear mesh. SENT from THE DARK SIDE of THE MOON |
|
| |
|
03-05-2019, 06:28 PM
| #4 |
| RCC Addict  Join Date: May 2013 Location: Forrestfield, Western Australia
Posts: 1,082
| Re: Notchy rear diff...
My first bet would be on the inner pinion bearing not being properly seated all the way into it's pocket, (can sometimes be a little plastic flash in the pocket) pushes the pinion in a little too deep & makes the gear mesh too tight. |
|
| |
 |
Notchy rear diff... - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gen7 portal axle notchy, especially after upgrade... | Everest10Dad | Redcat Crawlers | 5 | 04-05-2019 12:36 PM |
| New steel transmission gears notchy | Smokin' Joe | General Crawlers | 7 | 01-02-2018 05:56 PM |
| Front Diff to use as Rear Open Diff | ongbenghui | Vaterra Twin Hammers | 5 | 03-02-2017 12:54 PM |
| Locked Diff on the rear vs "Active" Diff | ongbenghui | Newbie General | 2 | 11-20-2016 01:51 AM |
| Spider gears in rear diff (aka losing the rear locker) | Sethmetal | Vaterra Twin Hammers | 2 | 02-26-2013 11:57 PM |
| |
Linear Mode
