Wraith Output in SCX10 Tranny This may have been brought up before but not sure cause I didnt find it. Well I want a Larger Spur Gear something like a 93 or 96 and I was wondering if I can take the Rear Output Shaft from a Wraith and put it on the Front Output Shaft of the SCX10 to clear the larger spur? If so where can I find just the Shafts from the Wraith? |
I'm not too sure that would work, the rear output shaft has a support bearing at the end where the shaft goes. The main bearing is also much larger. Here is some pics... Step by Step Wraith Kit Build - Part IV - Transmission This right here would be exactly what your needing....but you would have to use Traxxas T-maxx half shafts also. C.I. 4340 steel - Axial Trans Outputs for Maxx Shafts AX-10 & SCX-10 Parts |
yeah it wont work. they have a larger area where a larger bearing rides on it http://i113.photobucket.com/albums/n...0057Custom.jpg I suppose if you had it milled down, but at that point, there's probably an easier solution :roll: |
All times are GMT -6. The time now is 10:33 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com