scx10 2.4gh honcho problem
 

i apologize if im posting this in the wrong section, but i don't know where to post it. i just upgraded my scx10 honcho with the axial aluminum links, knuckes, and inner c's. everything seemed to go together pretty easy, excpt that now when i just give it a little throttle, the whole thing shakes like banshee. im not sure if i need to shim the upper links? my pinion angles looked okay but i cant seem to figure it out. oh, also it doesnt shake when im at full throttle though?


Rear
http://i372.photobucket.com/albums/o...nd954l/051.jpg

Front
http://i372.photobucket.com/albums/o...nd954l/050.jpg

video of it shaking
http://i372.photobucket.com/albums/o...54l/th_048.jpg

Re: scx10 2.4gh honcho problem
 

Re: scx10 2.4gh honcho problem
 

I couldn't watch your vid but did u weight your wheels? Maybe its a wheel balance prob? I guess if all else fails I'd take it a part and put it back together I don't drive very fast so I really don't notice that my wheels are waaaaay off balance good luck you'll figure it out

Re: scx10 2.4gh honcho problem
 

I'd put a $20 on it being the drive angle.. Check the drive shaft and make sure its not binding. put a few more spacers in your upper links and give it a try... Just give those pinion gears a tad of up angle.:mrgreen:

Re: scx10 2.4gh honcho problem
 

I was thinking it was the drive angle too, but I did some searching. And when I took the rear axle out I never made sure to realign the rear driveshaft. It seems that other people have had the same problem when they replaced the links. So I'm going to try and realign the driveshafts tonight. And there's no binding during articulation either on the shafts.

Re: scx10 2.4gh honcho problem
 

Better get your 20 bucks LOL naw its prolly is somethin like that I still have plastic shafts so I ain't much help in that department and I made my own links so I have no experience with axial links just keep at her you'll figure it out