Honcho bed side kit. So I cut out my bedside kit and all but my screw holes don't match up and I already drilled the holes, any advice would be appreciated. The back end not lining up is a no biggie, I'll use some screws to keep the rear ends aligned and to the Honcho body. http://i26.photobucket.com/albums/c1...k/DSCN3769.jpg http://i26.photobucket.com/albums/c1...k/DSCN3766.jpg |
Re: Honcho bed side kit. tuck the bed sides and rear under the "diamond plate". It will hide your previously drilled holes. I'd post a pic, but I'm at work right now...:cry: |
Re: Honcho bed side kit. |
Re: Honcho bed side kit. Brilliant, thanks guys! I'll definitely give it at shot. |
Quote: |
Re: Honcho bed side kit. Quote:
|
Re: Honcho bed side kit. Quote:
|
At first I thought that were taller than the dinky bedsides so I thought he might have found a sc body that lined up better but now that I look again I see |
Re: Honcho bed side kit. 1 Attachment(s) I had the same problem so I ovaled the wholes out then cut two strips if thick lexan off some spare stuff I had then drilled my holes and used them to go over top and hide the oval holes |
Re: Honcho bed side kit. 1 Attachment(s) Better pic |
All times are GMT -6. The time now is 05:13 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com