New scx10, new project.

[arctichorse]

So I got my new scx10 in November and so the projects have commenced. This is my second SCX10.

Axial Castle AE 2 ESC
Axial AX 2 2.4Ghz radio/receiver
Axial AS 3 servo (Have a Patriot 380 oz torque servo ready to replace that one)
Tekin 35T Heavy Duty motor
Punisher Drive shafts
Robison Racing output shaft
Robison Racing Idler gear
AJS ESC mount
DH Fab Honcho bumper

Runs great, I love it, I love the Axial Castle AE 2 ESC, it's exactly what I've wanted especially with an RTR, I'm very impressed with this RTR electronics.

[im gunna crawl]

Where did you get the bedside kit from it looks killer.

[arctichorse]

I got it off ebay. Ebay is the easiest way for me to buy online, a lot of websites don't use paypal and I only use palpal when shopping online.

Dinky R C's "Honcho" Bedside Kit Fits Axial SCX10 Honcho | eBay

[twisted concept]

what did you use to seal the esc? Any heating issues?

[arctichorse]

I used Plasti Dip, since I couldn't get the circuit board out of the case I dipped the whole ESC a couple of times then the next day I cut out the rubber around the heatsink. For heat, as long as the heat sink is not covered up, no heat issues, ran all day in 70 degree weather for several hours and it was just fine on temps. (knock on wood)