RCCrawler Forums - ElectroTech's Comancho

Finally finished building my SCX10. Thought I'd post up and get some opinions. This is my first scaler and It's not nearly as nice or and cool as some of the rigs I see on here.

So here's whats under the skin:

Holmes Hobbies BRXL
Holmes Hobbies 35T Torquemaster Expert (soon to be 27T Trailmaster Pro)
Castle 10A BEC
Hobbico CS-170 Stering Servo
Robinson Racing Trans Gears and Super Spur
Crawler Innovations Trans outputs short rear and extended front
Stock Driveshafts (I bought AX10 MIPs but they are too long???) need to find some shorter ones
Beef tubes front and rear
Axial front universals, aluminum steering links, High Clearance Knuckles, C-Hubs, and Lockouts
Hot Racing HD Lockers
HD Under drive rear, and over drive front bevel gears
Pro-Line Scaler Shocks
Blue Monkey delrin 3-link front and 4-link rear
Blue Monkey Knuckle Weights
Jevne Racing Electronics plate
Pro-line Comanche body, body cut off, Honcho Bed
Gear Head one9 six spoke delrin/aluminum wheels with RC4WD 1.9 Ikok tires

Onto Pics:
http://i96.photobucket.com/albums/l1...1A22B6BBD6.jpg

http://i96.photobucket.com/albums/l1...1A276F88B9.jpg

http://i96.photobucket.com/albums/l1...1A2B7148A0.jpg

http://i96.photobucket.com/albums/l1...1CC062390B.jpg

And the flex shots:

http://i96.photobucket.com/albums/l1...1A32B4377C.jpg

http://i96.photobucket.com/albums/l1...1A3D3149A6.jpg

Heading to the trails tomorrow so hopefully get some good actions shots.

Anyone know which drive shafts will fit the honcho with the extended trans output?
Also I'm a little concerned about width, i had to run the wheels with the hubs on the positive offset side to fit the knuckle weights and now it's 10" wide outside of the tires. I run this in local competitions and I believe they are 12" gates for 1.9 getting close I think the wheels/tires added about an inch over stock.