Rubicon kit question While assembling the first steps of my kit I noticed the axils closed alittle off. There was a slight gap off to the left, when it was all bolted down with the chubs it seems fine, but did any one else have this problem? All the gears turn but seem alittle stiff. http://i136.photobucket.com/albums/q...ps21f2da0a.jpg |
Re: Rubicon kit question That's normal. The important part is to be sure that you tighten the 4 screws on the housing evenly (careful with the top 2, they will strip if you go too tight). Then squeeze the ends together and slide the c-hubs on and screw them down. |
Re: Rubicon kit question Thanks ya I never over tighten anything on these anymore |
All times are GMT -6. The time now is 06:36 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com