|
| LinkBack | Thread Tools | Display Modes |
05-07-2013, 11:26 AM | #1 |
Quarry Creeper Join Date: Feb 2008 Location: Boise
Posts: 335
| Shorter MIP drive lines?
My current SCX10 project has shorter drive lines than stock and I'd like to upgrade to some MIPs (or something else burly, it should be the "last" upgrade from stock...). My questions is, what are my options? By the scx10 kit and cut it? Order something else? Is there a vendor here who will cut them? What are you running? |
Sponsored Links | |
05-07-2013, 11:30 AM | #2 |
Quarry Creeper Join Date: Jan 2013 Location: Vancouver, B.C.
Posts: 321
| Re: Shorter MIP drive lines?
You can order a spline for the DIG unit that will be making your scx-10 kit shorter. Look up on their site, there is many availible setup you can easily figure out.
|
05-07-2013, 11:48 AM | #3 |
Scale Detail Engineering Join Date: Apr 2010 Location: Turtle Island
Posts: 5,573
| Re: Shorter MIP drive lines?
or you can cut them down with a dremel cut off wheel.
|
05-07-2013, 11:54 AM | #4 |
Quarry Creeper Join Date: Jan 2013 Location: Vancouver, B.C.
Posts: 321
| Re: Shorter MIP drive lines?
Just order the proper lenght from the get go... MIP Spline CVD™ DIG Kit, Axial AX10 (rear) (1) #09137 assuming you run short front and rear, order 2 of these. If you need 1 long and 1 short, then order this: MIP Spline CVD™ DIG Kit, Axial AX10 (fr/r) #09136 *In some case, a cut shaft wont work because the spline are not going down to the base of the shaft, limiting how far it can be pushed in. |
05-07-2013, 11:55 AM | #5 |
Scale Detail Engineering Join Date: Apr 2010 Location: Turtle Island
Posts: 5,573
| Re: Shorter MIP drive lines?
and in some cases a dig shaft will not work because it's too short. |
05-08-2013, 09:51 AM | #6 |
Rock Crawler Join Date: Jan 2009 Location: Boise
Posts: 604
|
I am using a dig set from my ax10 with the first Dingo rtr and it has been working out for me. Sent from my SGH-T769 using Tapatalk 2 |
Shorter MIP drive lines? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drive lines... | Nova | Axial Wraith | 13 | 08-19-2012 07:29 PM |
Thread Tools | |
Display Modes | |
| |