back in the game well, little about me is I had a carrier change a few years ago and was forced to sell all my rc stuff. I was a hard core racer with trofies to show for it and at the end turned to crawling to save $. but that had to go eventually also. life has a way of coming back around with a better job and my first project is a scx10. got a used lightly used dingo rtr with a hitech wp servo, and the lower links and steering already swapped to alu. so far... replaced the esc it came with to the ae-5 27 turn stock motor (came with a 15 turn...saving it for snow plowing) proline swampers on 8 hole axial beadlocks 02 dodge hpi body mirrored the tranny trimmed the bumpers and side gaurds removed the stops and drained the shocks. next step and first question. 4 link? I did the serch and been looking, does anybody offer a complete setup to swap the upper Y link? I found the trusses and links and ends and ect ect. but would b nice to get a package deal. keep in mind I got my truck used and dint come with any extra parts. so spare parts trees are outa the ? going out to run the trails tomarow. will get picks up |
Re: back in the game couple poser shots http://i424.photobucket.com/albums/p...x/100_1502.jpg http://i424.photobucket.com/albums/p...x/100_1501.jpg ordered some strc front 4 link conversion, rear 4 link truss, and revo rod ends. how long are the rear links for a dingo? |
All times are GMT -6. The time now is 09:41 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com