Umg10 transmission

[jbone7678]

Hey guys, I'm doing a umg10 build and the transmission gears dont seem to mesh properly. Has anyone else had this problem and how did you fix it. I have torn it apart and reassembled 4 times without any luck. All help would be greatly appreciated.

[durok]

You're in the SCX10 "OG" section - but you're asking questions about the newer SCX10 II - try asking over here:

Scale Rigs Brand Specific Tech - Axial SCX10 II at RCCrawler.com

And there's a thread on this exact question here:

SCX10 or SCX10.2 transmission?

[Oh How Original]

Originally Posted by jbone7678

Hey guys, I'm doing a umg10 build and the transmission gears dont seem to mesh properly. Has anyone else had this problem and how did you fix it. I have torn it apart and reassembled 4 times without any luck. All help would be greatly appreciated.

You're in the wrong section, but it's more than likely the gears needing a little sanding.
If it's only tight/notchy in one place, get it to that point, then open the case up, keeping the gears were they are, inspect each one for anything that shouldn't be there.