Enduro Trans in Scx10??? I watched the video Harley put out with John Holmes. They said the Enduro trans has the same bolt pattern as Scx10. Have any of you done this? My Scx10 still has plastic gears and I was looking into getting steel gears for it. Then I seen that video. Around $30 for steel gears. Around $50 for the Enduro trans. I think the extra$20 for the trans would be well worth it. What's your thoughts on this? Also I have OD gears in the front axle. Any idea what the OD percentages with OD trans and diff gears? Thanks in advance for any information and knowledge on this! "thumbsup" |
Re: Enduro Trans in Scx10??? I put one in my SCX10ii. It was a direct swap. I went with the highest overdrive option in mine which I think was around 10%. There is an option to go with less but I don't remember what it was. |
Re: Enduro Trans in Scx10??? I recently built an SCX10 Cherokee with the element transmission from the get-go. Couple small mods are needed, it's in the build thread. |
Re: Enduro Trans in Scx10??? Yes you can bolt it straight up, the only things of note are that the enduro trans sits a couple mm higher so your driveshaft angles will be a bit steeper and the front facing side sticks out a bit more. I used it for the 12%(?) overdrive configuration combined with the scx10 II OD gears for around 20% OD. https://live.staticflickr.com/65535/...2909dcf8_o.jpg |
Re: Enduro Trans in Scx10??? Meh, just put Axial OD gears in front axle and/or UD in the rear. Personally I just ran OD fronts in mine, was plenty of overdrive. :) |
Re: Enduro Trans in Scx10??? Thanks for the responses guys. This might be the next upgrade the Dingo gets. Quote:
|
All times are GMT -6. The time now is 01:01 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com