Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

Been needing a transfer case output for my toyzuki build.... Eric from Dlux is open to make them if he can hit 10 orders... i ordered 5 to get the ball rolling"thumbsup" so if you have been looking for a axial AX31410 shaft, please “pre-order” one!

http://http://www.dluxfab.com/#!/PRE-ORDER-AX31410-Dlux-version-transmission-shafts-Axial/p/83618306

Re: Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

Why would one need these? Any good? Yesterday just placed my very first SCX10 II Kit. So, I wonder why slow crawler still need these ?

I only had full SuperShafty transmission in my Wraith.

Re: Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

I’m willing to bet there’s a Traxxas part out there somewhere that will work Just fine "thumbsup".
Get some numbered drill bits and and old broken slash drive shaft (or similar) and make one. "thumbsup"

Re: Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

I have a few shafts that “work” and am currently running a yeti transfer case output that “works”..:. However, for me, at $10 bucks, id rather loose slop in the drive train. Obviously running a 1.5mm pin in a 2mm hole isn’t optimum.

Re: Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

Use a 2mm pin and grind flat spots into the ends so the pin fits into the gear. That's what I did with my Toyzuki t-case and there is zero slop.

Re: Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

Any benefits for using these?

Re: Transfer case output shafts!!!! Axial AX31410 Dlux to the rescue
 

I can not believe i didnt think of that! "thumbsup"