And yet another 10.2 Newbie build

[lasllcap@gmail.com]

The first step of many. There might not even be an end; we'll see.

[RiderZ]

I've seen plenty of Axial builds over the years.Never gets old.
I'm going to watch.Continue!

[lasllcap@gmail.com]

Great. Please feel free to note anything that may seem amisss. I agonized over this front axel as the docs picture it and described Left and right as though you are t the front of the unit looking towards the back. Makes left and right easy to forget.

[lasllcap@gmail.com]

well, its not a roller yet , but we are getting closer.

Problems ? not too many:
Wrong t-case bearings
Motor mount screws, 3X8 supplied instead of 3X10
small do-dad that plugs servo actuator hole in trans case missing (caused a bit of consternation till I searched and got a clue as to what it was for. A bit of clear silicon sealer fixed that.

Soon as the replacement bearings and the shock towers get here./ will start on the chassis .

[mcbartho]

A lot of upgrades. Going strong

[lasllcap@gmail.com]

So... not many updates along the way; but I finally got there.
runs fine , haven't been out on the trails yet , using our landscaping rocks; still scouting out places.
Not much activity in this area any longer , apparently, but have not really asked around much.

Paint was the most recent thing.
Never did anything like this before, so took lots of time to think about the process.
Couple newbie glitches, but a very light coat of white and black made a passable primer gray repair type patch.

Next would be the exterior touches; rack, window tint, lights , etc.

[lasllcap@gmail.com]

Originally Posted by chino rc

love those wheels

SSD . Stock Cherokee kit BFG's; Trimmed the foams 1/4 inch (off the width) making it way easier to lock them in to the wheels.