Easiest/best way to power the led lights after changing out stock esc?
 

For the JK scx10.2. Looking at getting one soon and I know I'll change out the stock esc for a mamba x. So what would be the easiest/best way to repower the lights?

Re: Easiest/best way to power the led lights after changing out stock esc?
 

If you switch to deans connectors you could do something like this.

https://uploads.tapatalk-cdn.com/201...b92ecb475c.jpg

I use one on my Jeep to power the front led bar while the headlights and taillights are plugged into the 3rd channel on my receiver


Sent from my iPhone using Tapatalk

Re: Easiest/best way to power the led lights after changing out stock esc?
 

I should also mean room that when you switch out the esc you will also need to get the axial led light operator.

https://uploads.tapatalk-cdn.com/201...28ba2b7fff.jpg

That’s what I have plugged into the 3rd channel


Sent from my iPhone using Tapatalk

Re: Easiest/best way to power the led lights after changing out stock esc?
 

What did you use to connect them to your receiver?

Re: Easiest/best way to power the led lights after changing out stock esc?
 

See the post above


Sent from my iPhone using Tapatalk

Re: Easiest/best way to power the led lights after changing out stock esc?
 

Lol answered my question while I was typing it.

Thanks jason02ws6

Re: Easiest/best way to power the led lights after changing out stock esc?
 

How many VOLT can these Axial controllers handle?

Sent from my SM-G930F using Tapatalk

Re: Easiest/best way to power the led lights after changing out stock esc?
 

I do not believe that they are advertised as such, but I've been running 7.4v through the Axial light controller for close to 6 months, and it hasn't lit on fire yet.