ProLine 66 Bronco (Deadbolt) body on 10 II Kit?
 

Does anyone know if ProLine's 66 Ford Bronco body meant for the OG deadbolt will fit the 10II kit version? I'm thinking specifically of the kit clearance for the kit transmission. The bronco interior is a lot deeper and looks like it would probably interfere, I'm wondering if anyone knows one way or the other.


Thanks!

Re: ProLine 66 Bronco (Deadbolt) body on 10 II Kit?
 

I tried to used this shell on mine. It will fit if you have aftermarket sliders, the built in receiver box is right where the seats are on the bronco shell. You can cut the box off the slider and figure out another place for the receiver too.


Sent from my iPhone using Tapatalk

Re: ProLine 66 Bronco (Deadbolt) body on 10 II Kit?
 

Trans clearance didn’t appear to be an issue, just the receiver box I mentioned above.


Sent from my iPhone using Tapatalk

Re: ProLine 66 Bronco (Deadbolt) body on 10 II Kit?
 

Awesome thanks for the info that's a big help!

Re: ProLine 66 Bronco (Deadbolt) body on 10 II Kit?
 

I mounted mine by cutting the floor in a few spots.

Re: ProLine 66 Bronco (Deadbolt) body on 10 II Kit?
 

I'm mounting mine right now. Cutting the drivers floor out and boxing it back in with scrap lexan and super glue before paint.

Also need to tweak the sides with a heat gun and straighten them out to clear the sides, won't be running sliders with it, just for a clean look. Does fit without tweaking but will be a pain stretching the body over the sides when putting the body back on. Resting on top is a 1/4" too high for my tastes.

Does take some tweaking but not bad overall. Perfect ride height for me has the body resting on the trans, using rbk.