| |
04-24-2019, 03:15 AM
| #1 |
| Newbie Join Date: Jul 2014 Location: norway
Posts: 16
|  UMG10 CVD help
Can someone recomeny a CVD kit to replace the stock wildbord HD once. And what lenght do they need to be ?  |
|  |
| Sponsored Links | |
| | |
|
04-24-2019, 04:41 AM
| #2 |
| I wanna be Dave Join Date: Jun 2016 Location: Deep in the Everglades
Posts: 5,818
| Re: UMG10 CVD help
Two different parts, driveshafts (wild boar ) and the axels are cvds Hang up and Drive |
|
| |
|
04-24-2019, 07:05 AM
| #3 |
| Rock Crawler Join Date: Jan 2019 Location: Calgary
Posts: 566
| Re: UMG10 CVD help
Measure the length stuffed, measure the length unstuffed. There's your min and Max lengths. |
|
| |
|
04-24-2019, 07:44 AM
| #4 |
| I wanna be Dave Join Date: Jan 2005 Location: Raleigh-ish vicinity
Posts: 3,846
| Re: UMG10 CVD help
The front shaft will be the same as the SCXII Cherokee kit, while the rear will need to be about 25 mm shorter. Junfac lists their SCXII 12.3 inch wheelbase driveshaft set as coming with a 82-117 mm shaft for the front and a 120-155 mm shaft for the rear. With the shorter wheelbase of the UNG10, one of their 95-130 mm shafts would be used for the rear. Obviously you can go with your preferred driveshaft brand of choice but that should give an idea of the sizes needed. |
|
| |
|
04-24-2019, 07:59 AM
| #5 |
| I wanna be Dave Join Date: Aug 2004 Location: Tri-cities, WA
Posts: 4,831
| Re: UMG10 CVD help
Why change the driveshafts? WB8 HD are very nice shafts that are strong.
|
|
| |
 |
UMG10 CVD help - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axial SCX10 II UMG10 4WD rock crawler kit | celt | Axial SCX10 II | 72 | 05-19-2019 08:50 AM |
| Pre-Order NOW the NEW Axial Racing SCX10 II UMG10 Replacement Parts! | RPP Hobby | RPP Hobby | 0 | 04-12-2019 01:18 PM |
| Pre-order now! NEW Axial SCX10 II UMG10 4WD Kit! | RPP Hobby | RPP Hobby | 0 | 04-11-2019 09:24 AM |
| |
Linear Mode
