Super 300 interest
 

They are going to be cut soon, how many of you are interested so that I can gauge how many to run in the first run."thumbsup"

I would want a set I'm sure they'll run about 130 more or less I can go for that

Im def interested in a set

"thumbsup"

Count me in for a set "thumbsup"

Rob

Me too "thumbsup"

I would like a set but how much $$ are they going to be?

Yeah, Newb ?
 

I've read about them. but, with no explanation of their benefit. I am running a Tekin RX8 speedo and a SC4X 4.5 brushless. Will The Super 300 be to my liking?

I'd like to have a set or two.


Remember these are going to have to be like the AX10 versions which include a locker too. So they will likely be more than $130. I think the AX10 were in the $160 range.

Super 300 shafts are made from 300M chromoly steel which is an extremely strong material. The shafts are much stronger than any other shaft available to us and usually give you about 50 degrees of throw.

Will I still be able to use the Axial HD 36\14 R&P?

I've been waiting for these & would like two sets.

Please & thank you "thumbsup"

All the gear sets still work. You do have to open up where the shaft goes through with any gear you use though. Team 3six did a thread on how to install them I believe. Search for it.

Yes please! also, any chance of straight axle shafts that would work with ax10 housings with the wider beef tubes that kc jones sells? Looking for a center pumpkin rear axle to go with the wraith front.

Thanks Bro. Always good info from you.

I'd be all over a set.

I'd like to have two sets,please.

yes please.

Me too.