No info on here about DIG servo? info Help Please -------------- I opted to try out the Wraith DIG before jumping in using the ax10 tranny. Oviously THE Torque need for a Axial DIG is different than a newer wraith dig and even less torque needed to run a VP DIg for the ax10 tranny. So with that said, whatg is the recommended Torque / servo to run a wraith DIG? I searched for a few days and Got Nothing. I am guessing the torque need for grear performance would be in the range of 130-160oz torque..??? thanks |
Re: No info on here about DIG servo? info Help Please -------------- I'm using a Futaba S3305 on mine using the HR dig. I had it on my DNA dig on my AX trans, so I just swapped it over. |
Re: No info on here about DIG servo? info Help Please -------------- i am using a hitec 645 on my HR dig on my wraith and it works great for my rig |
Re: No info on here about DIG servo? info Help Please -------------- Thank you are you tough on it? |
Re: No info on here about DIG servo? info Help Please -------------- Yea pretty rough and probs. i had a jr 126 on it and I killed it so I went to a hitec 645 and haven't had any issues yet |
All times are GMT -6. The time now is 01:05 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com