|
| LinkBack | Thread Tools | Display Modes |
09-05-2012, 03:57 PM | #1 |
Quarry Creeper Join Date: May 2012 Location: Houston
Posts: 255
| Crawler Innovations Extended tran outputs
I bought these to use with the VP Trans Case, has anyone had issues with the bearing being very tight and not sliding over the outputs?
|
Sponsored Links | |
09-06-2012, 05:59 AM | #2 | |
RCC Addict Join Date: Dec 2008 Location: Sonora, CA
Posts: 1,664
| Re: Crawler Innovations Extended tran outputs Quote:
All is well after the minor repair. | |
09-06-2012, 06:53 AM | #3 | |
Rock Crawler Join Date: Jun 2011 Location: Las Vegas/671
Posts: 985
| Re: Crawler Innovations Extended tran outputs Quote:
| |
09-06-2012, 07:39 AM | #4 |
RCC Addict Join Date: Dec 2008 Location: Sonora, CA
Posts: 1,664
| Re: Crawler Innovations Extended tran outputs |
09-06-2012, 08:17 AM | #5 |
I wanna be Dave Join Date: Dec 2006 Location: Goin broke losing weight.....
Posts: 2,262
| Re: Crawler Innovations Extended tran outputs
Is the back of your output flat or does it have a high spot in the center? If its not flat, contact Eddie, he had some come in mismachined. I forget how much I removed, but cases would not shut. |
09-06-2012, 11:34 AM | #6 | |
Quarry Creeper Join Date: May 2012 Location: Houston
Posts: 255
| Re: Crawler Innovations Extended tran outputs Quote:
| |
09-06-2012, 11:53 AM | #7 |
RCC Addict Join Date: Dec 2008 Location: Sonora, CA
Posts: 1,664
| Re: Crawler Innovations Extended tran outputs |
09-07-2012, 02:32 PM | #8 |
Quarry Creeper Join Date: May 2012 Location: Houston
Posts: 255
| Re: Crawler Innovations Extended tran outputs
Yup that worked, bearings are on! Thanks buddy!
|
09-23-2012, 11:56 AM | #9 |
Tire&Foam Extraordinaire Join Date: Jun 2007 Location: C.I. Compound, Tyler, Texas
Posts: 5,601
| Re: Crawler Innovations Extended tran outputs
Thank you for your post and I am glad you got this worked out. I did have a few of the early run outputs get mailed out to customers and the tolerances were off. I believe everyone of those has been accounted for. The tight bearing tolerance is frustrating. I have noticed certain brands seem to fit better than other or are more consistent in fit. I used the emery cloth myself with no issues. If you outputs get rusty you may have to use the emery cloth again. I am also aware of tolerance issues with MIP drive shaft yokes. I have seen some yokes that are not drilled deep enough and would not allow the output to line up the cross pin hole. I have also noticed some of the yokes are to tight to install because the thickness of heat treated coating. |
Crawler Innovations Extended tran outputs - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My Extended Crawler | ebbet | Duratrax Cliff Climber | 4 | 11-15-2009 03:21 PM |
Losi Mini Crawler Extended Chassis | grizzly crawler | Losi Mini-Rock Crawler | 6 | 10-27-2008 08:33 AM |
| |