RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Axial Wraith (http://www.rccrawler.com/forum/axial-wraith/)
-   -   Advice on Electrical Issue (http://www.rccrawler.com/forum/axial-wraith/439950-advice-electrical-issue.html)

derek12v 04-15-2013 06:09 PM

Advice on Electrical Issue
 
I have a Holmes 13T & BRXL in my wraith and its been running great for me for over a year on 3S. I had an electrical failure where if I got it hot and stopped, it would not go again unless I bumped it to get it started. Figured the motor needed rebuilt and put the other new one in and it ran great for just a little while and started doing the same thing. I received the rebuilt 1st motor back from Holmes and installed it tonight and its doing the same thing and the controls are reversed. I left the leads on it when I sent it to Holmes and I can't tell where he took them off.

Question #1: Could the direction of the motor rotation be reversed during a rebuild?

Question #2: Is the failure where I have to push the crawler by hand when giving it throttle an issue with the motor or could it be the ESC or something else?

Thanks for any help. I just wanted to see if anyone had any advice before I bothered John with trying to send them both back and let him look at them.

Derek

winnerone23 04-15-2013 10:05 PM

For question one.. If you loosen the bell and rotate it 180° it will run the right direction.. Or its built right an ur TX is setup in reverse? Check settings..
For question two, it could be ur TX + rx giving the issue. Rx Could need rebound to the TX, then recalibrate ur ESC to the rx an motor

derek12v 04-16-2013 01:23 PM

Re: Advice on Electrical Issue
 
Thanks for the reply. I will re-bind and re-calibrate everything tonight and see if that fixes it.


All times are GMT -6. The time now is 07:41 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com