Wraith Chassis and Trans with Wheelie King Axles

[jeepnvinny]

Has anyone heard of someone mounting wheelie king axles on a wraith chassis? Any issues or pretty straight forward? Thanks

[OSRC]

Should be pretty simple. May need some sort of fab work for the upper links as the WK axles use a Y link. I bolt on a tamiya "shock mount" to the upper link to use 4-links,


Do believe WK axles use a 6mm input on the pinion as well, you'll need to swap it with a wraith 5mm shaft - it's a direct fit.

[jeepnvinny]

Originally Posted by OSRC

Should be pretty simple. May need some sort of fab work for the upper links as the WK axles use a Y link. I bolt on a tamiya "shock mount" to the upper link to use 4-links,


Do believe WK axles use a 6mm input on the pinion as well, you'll need to swap it with a wraith 5mm shaft - it's a direct fit.

Great, thanks. Do you have a pic of the completed Wraith King?

[greenjk]

Just saw this question, check out my build 1.9 Wraith a bit different

[jeepnvinny]

Originally Posted by greenjk

Just saw this question, check out my build 1.9 Wraith a bit different

I read through your post, where are you at with it as its been a few months since you updated it. Thanks for the info too!

[greenjk]

Originally Posted by jeepnvinny

I read through your post, where are you at with it as its been a few months since you updated it. Thanks for the info too!

I was very happy with the wraithking, but got a good offer on the axles and sold them, it has scx10 axles in it ATM but I'm building a set of narrowed wraith axles to go in it, the only down side to the WK axles IMO is the size of them around the chub/knukle area.