|
| LinkBack | Thread Tools | Display Modes |
02-23-2014, 12:45 PM | #1 |
Newbie Join Date: Feb 2014 Location: Portsmouth
Posts: 25
| Problems with Wraith Servo/BEC
I got my Wraith wired in but when I plug in the battery I'm still able to use my steering no matter if the switch it off or not. BEC has red wire removed and all connections are soldered and seem good. ESC is off with switch but still have steering. When we remove the BEC it works as it should. I'm using Savox 1270, MMP, and BEC. |
Sponsored Links | |
02-23-2014, 12:56 PM | #2 |
Shelf queen Join Date: Aug 2008 Location: Internet
Posts: 5,857
| Re: Problems with Wraith Servo/BEC
ESC should have the red wire removed and if BEC is plugged directly into the RX, then as long as the battery is plugged in, the rx will be getting power because the BEC itself does not have an on/off. Basically, you need to unplug you battery when you are not running it, which you should be doing anyways. Best to just leave the esc turned on, and use the battery as your on/off. |
02-23-2014, 02:55 PM | #3 |
Rock Stacker Join Date: Feb 2013 Location: NC
Posts: 63
| Re: Problems with Wraith Servo/BEC
Totally normal to happen |
02-23-2014, 06:53 PM | #4 |
Newbie Join Date: Feb 2014 Location: Portsmouth
Posts: 25
| Re: Problems with Wraith Servo/BEC
Thanks guys, wasn't sure if I was doing something wrong. |
Problems with Wraith Servo/BEC - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
bec problems | KnightRyder | Axial Wraith | 2 | 04-17-2012 10:42 PM |
Problems with Castle BEC on Wraith | TW31 | Axial Wraith | 8 | 01-31-2012 01:11 PM |
cc bec problems again | rottenbelly | Electronics | 2 | 10-10-2008 05:32 PM |
Thread Tools | |
Display Modes | |
| |