First Crawler build (Ghost Wraith)

[ElkoCrawler]

Bought this about a month ago and ordered a good amount of goodies to go on it too. wanted to stick with all raw aluminum parts to keep it "in my opinion" clean looking. started with a new Wraith Poison Spyder RTR. her is a list of what I've done.

Wraith Poison Spyder RTR
Venom 5500 2C Lipo
HR Aluminum Diff Covers
STRC Aluminum: Knuckles
Rear Lockouts
Steering Linkage
upper and lower arms
Hubs
Diff retainers
Front shock mounts
Top Cad: Carbon Drive lines
aluminum servo Mount
Aluminum 5mm spacers
4" Piggy back Shocks
AMF Aluminum: Front and rear Diff skid plates
Under Belly skid plate
Racers Edge aluminum servo horn
Full Stainless Hardware Kit

mods i did were full water proofing, Battery relocated to front, ESC to the rear, Rear shock mount flip, shocked moved to the lower arms, Body trimmed to normal wraith fitment, changed body design to Rogue Graphics White skull and droop setup. have had lots of fun putting it together while the weather had been bad and now that i'm mostly finished i'm itching to get it out and see how it crawls.

When I got it


As of 4/5

[creepinchevy69]

Looks damn good man those rogue graphics really set the rig off! Hope you dont mind me askin what the "rear shock mount flip" is too?


- Richard

[ElkoCrawler]

Thanks. The rear shock mount flip is to lower the rear a little. Less roll overs.

[ElkoCrawler]

Snapped a quick photo today during maiden voyage. was a blast. dug some holes and found some old concrete chunks to start making a course.

[ElkoCrawler]