| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
06-19-2014, 12:18 AM
| #1 |
| Newbie Join Date: Mar 2014 Location: Hillsboro
Posts: 29
|  Robinson Racing idler gear
Just added a Robinson Racing Idler gear to my Wraith after it ate the stock plastic one. I noticed the bearings don't fit very tight and one sticks out a little on one side. Is this typical?
|
|  |
| Sponsored Links | |
| | |
|
06-19-2014, 01:05 AM
| #2 |
| Quarry Creeper Join Date: Oct 2010 Location: Nashville TN
Posts: 347
| Re: Robinson Racing idler gear
clean everything very thoroughly. there might be a sliver of plastic from the old gear in there somewhere.
|
|
| |
|
06-19-2014, 09:47 AM
| #3 |
| Newbie Join Date: Mar 2014 Location: Hillsboro
Posts: 29
|
I did. Even swapped the bearings. Compared to the old gear the new one is a little thinner too. Sent from my XT912 using Tapatalk |
|
| |
|
06-19-2014, 02:21 PM
| #4 |
| Newbie Join Date: Mar 2014 Location: Hillsboro
Posts: 29
|
Found a bit of a lip on the side the bearing isn't flush. Guess I'll need to contact the seller for a new one. Sent from my XT912 using Tapatalk |
|
| |
|
06-19-2014, 03:12 PM
| #5 |
| Rock Crawler Join Date: May 2014 Location: Cluj-Napoca,Romania
Posts: 650
| Re: Robinson Racing idler gear
never had problems with robinson products.get a email to them and tell them about the problem
|
|
| |
|
Robinson Racing idler gear - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Robinson racing Gear Breakage | Jacksprogis | Axial Wraith | 11 | 09-15-2013 01:30 PM |
| Robinson Racing Diff Gear | rc crawler boy | Axial Wraith | 2 | 04-08-2012 02:03 PM |
| Robinson Racing 2 day sale on 1541 Idler gear | THE PARTS GUY | Vendors Market | 0 | 05-26-2010 07:49 PM |
| Robinson Racing Pinion Gear?? | Steve at Danfor | Axial SCX-10 | 12 | 03-28-2009 11:06 PM |
| Robinson Racing gear question | bagged92sdime | Traxxas Crawlers | 8 | 04-21-2007 04:33 PM |
| |
Linear Mode
