02-23-2016, 06:34 PM | #1 |
Pebble Pounder Join Date: Jan 2016 Location: Anderson, CA
Posts: 154
| Robison gen3 slipper
Waist of money or decent product? Being a newb, I bought one used without searching beforehand. I noticed right away after receiving it that my top shaft was not going to work with it. I figured out that I either needed an older shaft that uses a pin for the slipper/spur or just upgrade to the Supershafty version. My top shaft is slotted... Having taken a decade off from RC, I just assumed that Robison was the good stuff. Have their products gone down hill over the past few years? After a quick search, it seemed that people where having issues with this particular slipper. Any advice would be appreciated. |
Sponsored Links | |
02-23-2016, 06:45 PM | #2 |
Quarry Creeper Join Date: Oct 2014 Location: yakima
Posts: 221
| Re: Robison gen3 slipper
You can't get no better than your purchase robinson Is bad ass shit top shelf get yourself the supershafty beefy top shaft and you are golden!!! " Thumbs-up "
|
02-23-2016, 07:09 PM | #3 |
Pebble Pounder Join Date: Dec 2012 Location: Vancouver
Posts: 188
| Re: Robison gen3 slipper
What he said^^ I have the same setup, zero problems.
|
02-23-2016, 07:18 PM | #4 |
Pebble Pounder Join Date: Jan 2016 Location: Anderson, CA
Posts: 154
| Re: Robison gen3 slipper
Cool. Thanks, guys. I already have the Robison idler gear and one piece locker so it made sense. I should start a build thread. You could point out my mistakes as I make them.
|
02-23-2016, 08:34 PM | #5 |
RCC Addict Join Date: May 2013 Location: Forrestfield, Western Australia
Posts: 1,082
| Re: Robison gen3 slipper
You must have a Spawn with the dual slipper spur, yeah it's got a different top shaft to the other Wraiths. Have you got the RR Wraith 80T slipper? I'm not sure if that slipper is a direct fit with the SuperShafty top shaft, the shaft has a 2mm cross pin to suit the 2wd Slash slipper. The stock top shaft only has a 1.5mm cross pin & the Robinson 80T slipper might only have a pocket to suit that. Which is not to say the pocket couldn't be opened slightly with a dremel to suit the SS 2mm pin, just it might not bolt straight up. |
02-23-2016, 08:58 PM | #6 | |
Pebble Pounder Join Date: Jan 2016 Location: Anderson, CA
Posts: 154
| Re: Robison gen3 slipper Quote:
| |
Robison gen3 slipper - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gen3 slipper issue | Bogncrawl | Axial SCX-10 | 1 | 01-04-2014 12:10 PM |
| |