| |
05-16-2016, 11:19 PM
| #1 |
| Newbie Join Date: Feb 2016 Location: Central Florida
Posts: 5
|  Vanquish help
Ok guys I just replaced my knuckles and c hubs from my old strc ones to the VP scale knuckles and hubs. Also did the VVDs. Upon assembling everything I'm running into an issue where the knuckles don't flit flush with screw holes. They almost need to be forced while trying to put the top screw in which causes the knuckles to be very tight. All my VP stuff has always been nice and smooth and easy but these have been giving me a hell of a time any ideas ?? On a wraith by the way with stock AR60's |
|  |
| Sponsored Links | |
| | |
|
05-16-2016, 11:32 PM
| #2 |
| I wanna be Dave Join Date: Aug 2004 Location: Tri-cities, WA
Posts: 4,831
| Re: Vanquish help
Pull the c hubs and knuckles off the housing. Can you assemble the knuckle onto the c hub easily now? Will the axle shaft assembly slid into the locker easily?
|
|
| |
|
05-17-2016, 04:02 PM
| #3 |
| Quarry Creeper Join Date: Feb 2015 Location: Norway
Posts: 379
| Re: Vanquish help
I had the same problem, had to grind my cvd's abit.
|
|
| |
 |
Vanquish help - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vanquish Currie F9? Vanquish Jockrocks? SSD Diamond Axles? | 701scaler | General Crawlers | 6 | 01-04-2016 10:06 AM |
| vanquish wraith link on ar60 axle with vanquish xr10 knuckles? | T3rry | Axial AX10 2nd-gen | 2 | 04-28-2013 06:11 PM |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
