Rocker plates I was looking around the shop for something to mount my light bar and ran across some thick scrap aluminum. It's about 3mm thick and I originally thought it's just the right size for a rear body plate. As I was cutting it down I thought where else can I put them and it just so happens that it matches up quite well on the rockers. Drilled a few holes and I think they look pretty good. I do want to improve the mounting as the 2mm machine thread screws don't grab well in the tired holes but the LHS doesn't carry 2mm nylock nuts and even if they did, mounting them could be a pain. https://www.dropbox.com/s/xabrse0vag...0.02.jpg?raw=1 https://www.dropbox.com/s/1wl1lu3b08...0.21.jpg?raw=1 |
Re: Rocker plates 2mm screws never going to hang on well there if its ever originally had the stock 2.6mm fitted, I'd be looking for a bit larger button head screw |
All times are GMT -6. The time now is 10:30 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com