Wraith transmission case Hello, I want to replace stock plastic transmission case for aluminium one’s. Is there any model that fit w/o swap any stock part, gears, axles... Best regards |
Re: Wraith transmission case Look at the VP vanquish products. I built mine based on that and the super shafty bombproof https://uploads.tapatalk-cdn.com/201...b3571c07e5.jpghttps://uploads.tapatalk-cdn.com/201...680b26029e.jpg Hang up and Drive |
Re: Wraith transmission case If you haven't swapped out the stock gears for metal yet that'd be a better spend than the trans case. Wraith trans theres a few options but VP isn't one, you'll need to change the rear output to suit that (AX10/SCX10 trans basically) The HR one in the pic above is available from Tower & RPP https://www.towerhobbies.com/cgi-bin...?&I=LXFHTS&P=7 Hot Racing Black Aluminum Wraith Transmission Case Then theres also GPM for AXIAL Wraith #WR038-GS (FREE SHIPPING), ,(WR038-GS) by GPM Aluminum Alloy Transmission Case Grey Silver https://www.asiatees.com/display?Axi...id=61836&pid=1 and Boom have one also https://www.asiatees.com/display?Axi...d=116523&pid=1 |
Re: Wraith transmission case Quote:
|
Re: Wraith transmission case 1 Attachment(s) Quote:
The SCX10 GPM case I have was another matter. Same HR gears but the bosses at the mid shaft bearings were too large & kept the case apart. Took just touch with a counter sink bit (yes an end mill would be the correct tool but I didn't have one to hand) to remove enough material to fix but does show their consistency isn't quite 100% |
Re: Wraith transmission case I got rid of the stock plastic when I stripped the gears. Right now I run the Team GPM #WR038. Not one issue with it. All the bearings and upgraded metal gears from axial fit perfectly. No need to shim or anything. |
Re: Wraith transmission case the VP SCX10 transmission cases are also very good. I use that with Super Shafty Beefy top shaft, motor plate, 6mm output shafts, Robinson Racing slash slipper, and metal internal gears. No issues and spins great. |
Re: Wraith transmission case Finally I bought GPM aluminium case. Thank you guys! |
All times are GMT -6. The time now is 04:06 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com